|
PLCS Test Ends are designed to
easily pressure test (up to 150 psi.) any length of PE pipe.
- Insert
directly into the open PE pipe end without special preparation.
- Tighten
the nut and the grippers lock into position, but release immediately
on demand.
- PLCS
Test Ends have been tested to the point of pipe failure without
pressure release.
- Once
set correctly, gripping power increases as the test pressure rises.
- Can
be operated together with PLCS Pressure Tight Pipe Pullers to
seal both ends of any length section of PE pipe for on-site testing.
- Used
together, as above, they provide a total barrier to ingress of
water or mud into the PE pipe, under even the worst site conditions.
- Heavy-duty
construction in plated steel for rugged durability.
- Minimal
maintenance and fully replaceable components.
- Full
½" to 8" size IPS size range. Much
less expensive than fusing a disposable PE fitting on each time.
- The
original Pipe Test End, in service for more than 20 years.
Home
|
