Provide
an easy direct connection between PE pipe and any form of pipe
laying equipment. The design is in use on many directional drilling
rigs and is recognized as the most reliable connector in the
industry.
Insert
directly into the open PE pipe end without special preparation.
Twist the eye and the grippers lock into position without the
use of wrenches, but they release on demand.
Gripping
power increases with pulling load. Pipe yield point is reached
before puller will release.
Never
again will you have to search for the end of your pipe because
your pipe puller has let go.
Pays
for itself many times over in lost production time saved.
Heavy-duty
construction in plated steel for rugged reliability.
Full
¾" CTS to 16" IPS size range
and cover SDR 9 to SDR 17.6
The
rear eye can be used to pull a cable for various uses, including
pulling sections of PVC carrier pipe.
PRESSURE TIGHT
These have all the attributes of standard Pipe and Duct Pullers,
without the rear eye, plus:
They
have an extra sealing mechanism to completely seal the end of
the pipe against ingress of water or mud.
When
used together with a PLCS Test
End they seal both ends of any length of PE pipe so that
it can easily be tested (up to 150 psi.) on site, prior to placing
in service.
Special
sizes of both types of pullers are available upon request.
