| Available SIZES |
PART # |
| 1/2" CTS |
71-401015 |
| 3/4" CTS |
71-401022 |
| 1" CTS |
71-401029 |
| 1-1/4” CTS |
71-401035 |
| 1-1/4" IPS |
71-401042 |
| 1-1/2" IPS |
71-401048 |
| 2" IPS |
71-401061 |
| 3" IPS |
71-401090 |
| 4" IPS |
71-401115 |
| 5" IPS |
71-401140 |
| 6" IPS |
71-401168 |
| 8" IPS |
71-401219 |
| *10" IPS |
*71-401273 |
| *12” IPS |
*71-401324 |
PLCS pipe & duct pullers cover a range of pipe SDR's from 11 to 17.5
*These items are special order only.
Other sizes available upon request.
|
- Insert directly into open PE pipe end without special preparation.
- Twist the eye and the grippers lock into position without the use of wrenches, but release immediately on demand.
- Once set correctly, gripping power increases with pulling load. Pipe yield point is reached before failure can occur.
- Standard equipment for all types of directional drilling rigs and ideal for laying large diameter PE coils
- Heavy duty construction in plated steel for rugged durability.
- The original pipe puller, in service for more than 20 years.
- Minimal maintenance and replaceable components.
- Full 1/2" - 16" size range.
- PLCS Pipe & Duct Pullers fit PE pipe across a wide range of SDRs (11 -17.6).
- The rear eye can be used to pull cables or other conduits at the same time.
- Also available in a Pressure-Tight design to block ingress of mud, groundwater and sewer gas into the interior of the PE (see additional PLCS literature).
|
